Kodak 2400DSV-E - Correcting Image Distortion

A-61316 September 2004 3-23
Correcting Image
Distortion
User mode allows the default values of various functions to be set or
changed as necessary. Most of these functions are set-up and changed
by your Kodak representative, however some User modes can be
changed by you.
1. Press and hold the Shift key and the Output Selection key to enter
User mode.
2. Select U2.
3. Press the Exposure Mode key to display d*. The table below shows
the amount of correction based on the setting value:
Code Setting Value
d0 0 mm
d1 0.5 mm
d2 1.0 mm
d3 1.5 mm
d4 2.0 mm
d5 2.5 mm
d6 3.0 mm
d7 3.5 mm
d8 4.0 mm
4. Press the Exposure Adjustment key (Darker or Lighter) to select the
desired setting value.
5. Press the Start key to validate the setting.
NOTE: This setting returns to the default value (d3) when the Power
switch is turned off. You can register the setting value using the
Job Program function.