A-61316 September 2004 B-1
Appendix B User and System Settings
This system offers two types of settings:
• User settings that are setup by the operator from the control panel
• System settings that are setup and can be changed by the Kodak
Service Representative.
Following is a list of factory settings:
User Setting Factory
Setting
Comments
Exposure mode Auto
Print image density Center
Print format Portrait
Film type Auto
Auto skew correction Off
Auto masking Off
Manual masking - Enabled only when the optional
Manual Frame Masking Kit is
installed.
Centering/Fit Off
When any of these functions has been changed and you want to store the
new setting in the system’s memory, press the Memory Input key.
System Setting Selection Default Description
Auto reset Enabled
Disabled
Enabled
Setting changes made to the control panel that are not
used within 60 seconds of being input are automatically
cancelled and the system reverts back to the original
settings.
Auto power save
(PR mode only)
Disabled
30 min.
60 min.
Disabled
Turns the printer’s fuser off if the system is left idle for a
specific period of time.
NOTE: 230V units operate on a 30-minute Auto Power
Save setting.
Auto Projection Lamp
OFF
Disabled
30 min.
60 min.
Disabled
Turns the projection lamp off if the system is left idle for a
specified period of time.
Fine mode contrast select Contrast
Emphasis
Outline
Emphasis
Contast
Emphasis
Applies the following functions as required:
Contrast Emphasis: applied when film contains text
that is poorly contrasted against its background
making it difficult to read.
Outline Emphasis: applied when film contains blurred
black and white images.
To Next Page
Loading...
