4-64 A-61635 December 2010
Image Index File To set up an Image Index file:
1. Select Image Index file.
2. Select the desired index file type.
• If you selected Text (delimited), click Options and click either ASCII or
Unicode, then click OK.
• If you selected HVCS 16-bit Format, click Options and enter the
Client number (1-999) and Application number (1-9), then click OK.
3. If desired, click Setup to display the Location Setup dialog box to create a
path for your outputted image index file. See the section entitled, “Building
location and filename formulas using the Location Setup dialog box” later
in this chapter.
4. If desired, click Content to display the Index Content Setup dialog box and
define the index content. By default, the image index file will contain only
the image indexes defined for this job. Use the Content button to add or
remove index values or to reorder indexes in output. See the section
entitled, “Using the Index Content Setup dialog box” later in this chapter.
5. When finished, click OK.
To Next Page
Loading...