4-10 A-61635 December 2010
Separation settings —
Capture tab
The Separation option on the Capture tab allows you to identify how you want
to separate batches and documents for this job. There are several ways to add
separators to your batches. The following list provides the options you can use
to create separation settings in Kodak Capture Pro Software:
• with a bar code zone (see Chapter 6, Bar Code and OCR Setup)
• with an OCR zone (see Chapter 6, Bar Code and OCR Setup)
• with Patch codes 2, 3 or T (see Chapter 5, Patch Code Setup)
• by automatically counting pages in a document(s) in a batch (set this option
up using the By Count option)
• with a blank page (set this option up using the By Blank Page option)
• by selecting Document>New or Batch>Next
• by pressing Enter during scanning
• by right-clicking on a page file in the Batch Explorer and clicking Split
The sections that follow provide information and procedures for using Kodak
Capture Pro Software to automatically separate documents or batches by
counting pages and how to use blank page separation.
By Count The By Count separation setting on the Capture tab allows you to enter the
number of documents that each batch will contain, and the number of pages
each document will contain.
1. Choose Batch Level and/or Document Level.
2. Click Every at the Batch Level and enter the number of documents that
the batch must contain before a new batch is created.
3. Click Every at the Document Level and enter the number of pages that a
document must contain before a new document is created.
To Next Page
Loading...