11-2 A-61635 December 2010
Clearing errors The Kodak Capture Pro Batch Status window provides information on batches
that you are preparing for output from Kodak Capture Pro Software.
To view the Batch Status window:
•Select Batch>View Batch Output Status.
To clear the errors:
• Click on the Job Name to Clear All Errors or Clear Selected Errors.
Command line login Capture Pro Software will support a login from the command in the form:
Capture.ex
e/username<userna
me>/password<password>
For example, a user with the username “tester” and password “123465” could
launch Capture Pro Software with the command:
Capture.exe/username tester/password 123465
If the user is using the current Windows user name to log into Capture Pro
Software, then they may launch Capture Pro Software with the command:
Capture.exe/username
Problem Possible Solution
Conflict found or installation problem
that prevents patch code (or bar code)
functions from working
The conflict may be caused by an older version of an AMP release or
toolkit (from All My Papers) that was installed on your PC. If any of the
following AMP DLL files are present in the Windows\System32 directory
on your PC, then this is the cause of the conflict:
amplm.dll
amplib.dll
ampPX.dll
To resolve the conflict, remove these DLL files from the System32
directory and restart Capture Pro Software.
Newly developed System Output
Destinations do not appear in the Job
Setup>Output>System "Send to"
drop-down list
This may be caused by a missing Microsoft Windows component which
is required for newer System Output Destinations to run properly.
To resolve the issue, visit the appropriate Microsoft link below, and follow
the instructions for download and installation:
http://www.microsoft.com/downloads/details.aspx?familyid=200B2FD9-
AE1A-4A14-984D-389C36F85647&displaylang=en
http://www.microsoft.com/downloads/details.aspx?familyid=A5C84275-
3B97-4AB7-A40D-3802B2AF5FC2&displaylang=en
To Next Page
Loading...