F-2 A-61635 December 2010
Creating job setups Job setups are created the same way with the Scan Station Pro 550
Administration as they are with Kodak Capture Pro Software with the
exception of when scanning for barcode and OCR samples.
NOTE: For the Scan Station Pro 550 Administration, clicking the Scan button
on the Barcode/OCR screen will result in prompting the administrator
to select the image file to import for OCR/Barcode selection.
Associating a page
setup with a job
setup
As part of creating a job setup, a specific page setup is required to be used.
This is done by accessing Job Setup>General tab using Kodak Capture Pro
Software.
1. From the Current Page Setups: Current Source, select i1220.
2. Select the desired page setup for the job setup you are configuring from
the Current Page Setup drop-down list.
3. Click OK.
Network credentials To allow the Scan Station Pro 550 to communicate over the network, you need
to enable network credentials. To do this:
1. In Capture Pro Software, select File>Network Credentials. The Network
Credentials dialog box will be displayed.
2. Enter your Username, Password and Domain or Workgroup
information.
3. Click OK.
To Next Page
Loading...