4-78 A-61635 December 2010
Setting up a stamp string To setup an image stamp string, do the following:
1. Click Setup on either the Front or Back section. The Stamp String Setup
dialog box will be displayed.
2. Select the items from the list of available Stamp String formulas that you
want to include in your stamp string. For each item you select, click Add.
NOTES:
•The Add leading zeros and Number length fields become available
when you select the following: Document ID, Page Sequence
Number, Image Sequence Number, Image Address Level 1, Image
Address Level 2, or Image Address Level 3. When selecting Page
Sequence Number or Image Sequence Number you will also have
the option to specify when the page or image sequence number should
be reset and the value to which it should be reset.
• To remove an item from the stamp string formula, click Delete Item.
• To delete an entire formula from the stamp string formula, click Delete
Formula.
3. When finished defining your stamp string, click OK.
4. Define the location of the stamp string by specifying the placement of the
image stamp on either side of the page. Margin defines the size of the
border between the text and adjacent page edge(s), either from the right or
left edge horizontally and top or bottom edge vertically. If Middle is
selected, the margin in only applied to the vertical dimension.
5. Select the desired font size: 16 or 18.
To Next Page
Loading...