A-61635 December 2010 7-3
2-sided mode — select Classic or Calendar mode from the drop-down list for
two-sided scanning and the corresponding icon will be displayed. Compare
your original image with the icon to determine if it has a classic or calendar
layout.
• Classic: typically used for multi-page reports. The 2-sided mode option
only influences the way the front image is rotated in relation with the back
image. It does not set the overall rotation of the document (0
°, 90°, 180° or
270
°).
When using Classic: 2-sided mode, the front and rear images correspond
as follows:
A 0
° rotated front results in a 0° rotated back.
A 180
° rotated front results in a 180° rotated back.
A 90
° rotated front results in a 270° rotated back.
A 270
° rotated front results in a 90° rotated back.
• Calendar: typically used for presentation handouts, financial reports, wall
calendars, etc. The 2-sided mode option only influences the way the front
image is rotated in relation with the back image. It does not set the overall
rotation of the document (0
°, 90°, 180°, or 270°).
• When using the Calendar: 2-sided mode, the front and rear images
correspond as follows:
A 0
° rotated front results in a 180° rotated back.
A 180
° rotated front results in a 0° rotated back.
A 90
° rotated front results in a 90° rotated back.
A 270
° rotated front results in a 270° rotated back.
Image order — select an image and use Move Up or Move Down to change
the image order listed in the box.
Overcrop — enable this checkbox to trim all edges of the image by the
amount you specify in 1/100ths of an inch.
OK — saves your settings and closes the dialog box.
Cancel — closes the dialog box. Your entries are not saved.
Apply — accepts the changes made in the dialog box.
To Next Page
Loading...