Kodak DirectView CR 825 - Storing the Error Logs on a Disk

INSTALLATION INSTRUCTIONS Installation
10MAR06
II4825-1
Page
52 of 72
2 At the “Installed Destinations” window, touch:
• [Add]
• [Store]
• [Network]
• [Qualified]
3 Touch [OK].
4 At the “General” window, type:
• “Logical Name”
• “IP Address”
5 Touch [Finish].
6 In the “DICOM Information” window,
type the correct information:
• “Port Number”
• “AE Title”
• “Response Message”
7 Touch:
• [OK]
• [Set]
8 At the “Installed Destinations” window,
click [Close].