Kodak EasyShare DX4530 User Manual

75
Chapter 10
Camera/Computer Communications
Problem Cause Solution
The computer
cannot
communicate
with the camera.
Camera power is off. Turn on the camera
(page 7).
Battery is not charged. Replace (page 5) or recharge
the batteries (page 66).
Some Advanced Power
Management utilities on
laptops can turn off ports
to save battery life.
See the Power Management
section of your laptop user’s
guide to disable this feature.
USB cable is not securely
connected.
Connect cable to camera and
computer port (page 59).
Software is not installed. Install the software
(page 55).
The Battery Monitor or
similar software runs
constantly.
Close that software before
starting the Kodak EasyShare
software.
Cannot transfer
pictures to
computer. The
Add New
Hardware
Wizard cannot
locate drivers.
Software is not installed
on computer.
Disconnect USB cable (if using
camera dock, disconnect
cable and remove camera
from dock). Install Kodak
EasyShare software (page 55).

Kodak EasyShare DX4530 Specifications

General

Megapixel	5 MP
Sensor type	CCD
Digital zoom	3.3 x
Optical zoom	3 x
Combined zoom	10 x
Focal length range	8 - 24 mm
Metering	automatic: multi-pattern TTL-AE
Interface	Dock Compatibility - KODAK EASYSHARE Camera Dock I, II and KODAK EASYSHARE Printer Dock 4000
Cable type	1 x A/V cable, 1 x USB cable
Minimum RAM	64 MB
Minimum processor	233 MHz
Dimensions (WxDxH)	111 x 66 x 39 mm
Camera shutter speed	1/2-1/1700 s
Minimum storage drive space	200 MB
Minimum system requirements	CD-ROM USB
Focal length (35mm film equivalent)	38 - 114 mm
Viewfinder type	Optical
Internal memory	32 MB
Compatible memory cards	mmc, sd
Display diagonal	1.8 \
I/O ports	1 x USB 1 x composite video/audio output 1 x docking station 1 x DC power input
Bundled software	KODAK EASYSHARE Software
Self-timer delay	10 s
Tripod mounting supported	Yes
Product color	Silver
Flash modes	Red-eye reduction

Weight and Dimensions

Weight	210 g