Kodak Scan Station 710 - Page 51

A-61796 September 2014 5-9
• Streak Filter: allows you to configure the Scan Station to filter vertical
streaks from your images. Streaks are lines which may appear on an
image and are not part of the original document. Streaks may be
caused by contaminants on your documents (e.g., dirt, dust or frayed
edges) or by not following the recommended cleaning procedures for
your Scan Station. Click Streak Filter to turn this option on where
you can select an Aggressiveness value which allows you to adjust
the extent at which the streaks are filtered. The values range from -2
to 2.
• Color Dropout — used to eliminate a form's background so that only
the entered data is included in the electronic image (e.g., remove the
form’s lines and boxes). For black and white images, these settings
affect the grayscale version of the document which the Scan Station
analyzes to produce that electronic image. This option is only
applicable for grayscale and black and white images. Select one of
the following options:
- None
- Multiple: drops colors other than dark shades (e.g., black or dark
blue ink)
- Predominant: drops the predominant color
-Blue
-Green
-Red
When you select Multiple or Predominant, you can adjust the
Aggressiveness value to the extent at which colors are dropped.
The values range from -2 to 2. The default is 0.
Combine Front and Back Images — typically one image is created for
a document the front side and another image is created for the back
side. Turn this option on if you want one image that contains both the
front side and back side of the document. Select one of the following
options:
• None
• Front on Top: front side will be above the back side within the image.
• Front on Bottom: back side will be above the front side within the
image.
• Front on Left: front side will be to the left of the back side within the
image.
• Front on Right: back side will be to the left of the front side within the
image.