2-2 A-61660 July 2013
Attaching the feeder
tray
1. Install the left side of the feeder tray by inserting the pin located at
the left side of the feeder into the hole.
2. Install the right side of the feeder tray by inserting the pin located at
the right side of the feeder into the hole. A small amount of pressure
will be required to align the pin with the hole.
Making connections 1. Turn the host PC off.
2. Plug the power cord into the AC power input on the back of the
scanner and connect the other end to a power outlet.
3. Connect the USB cable to an available USB 2.0 port on the host PC
and connect the other end to the USB port on the scanner.
NOTE: Do not connect the scanner to a USB hub.
To Next Page
Loading...
