4-2 A-61660 July 2013
Accessing Advanced
features
To access the VRS Interactive Viewer, VRS Professional software must
be loaded on the host PC that the scanner is connected to. VRS
Professional will be active when the scanning application being used is
launched and a VRS scan source is selected. There are three types of
scan sources, depending on the VRS driver used.
• VRS ImageControls®-based Applications
• VRS ISIS-based Applications
• VRS TWAIN-based Applications
NOTE: This User’s Guide only documents the VRS-based scanning
setup.
To open the VRS Test Application:
1. Select Start>VRS Test Application.
The VRS Test Application (VCDemo) screen will be displayed.
2. Select Scanner>Source to connect to the scanner.
3. When the scanner is connected, select Source>Advanced
Properties to setup your scanner properties.
To Next Page
Loading...
