A-61660 July 2013 6-5
Cleaning the rollers in the
Exit area
Cleaning the drive rollers, free rollers and exit rollers in the exit
door
1. Pull the exit door release lever to open the exit door.
2. Use the roller cleaning pad to remove the dirt from the surfaces of
the four drive rollers and the two exit rollers.
3. Use the roller cleaning pad to remove the dirt from the surfaces of
the six free rollers.
4. Gently close the exit door.
5. When finished, turn the scanner on.
6. After cleaning the rollers, open the User Utility and click Clear
Counter to clear the roller counter. For more information, see the
section entitled, “Scanner counter” in Chapter 5, Trūper User Utility.
To Next Page
Loading...
