A-61660 July 2013 1-3
Scanner components
Front view — Kodak Trūper 3610 Scanner
Power indicator — lights when the power to the scanner is on.
Stop/Start button — starts or stops scanning.
Transport cover — provides access to internal components.
Auto/Manual feed selector — set this selector to AUTO if you are
feeding a stack of documents. If you are feeding documents one at a
time, set the selector to MANUAL.
ADF door release — push this button to open the ADF door.
ADF door — provides access to the Automatic Document Feeder.
Document guides — slide the document guides in or out to
accommodate the size of the documents you are scanning.
Separation roller — allows the paper feed roller to feed a single
document into the scanner.
Feeder tray — holds documents in place for automatic or manual
scanning. The documents should be placed face-up to ensure they are
scanned in the correct order.
Feeder tray extension — pull this extension out to accommodate
document sizes longer than 11 inches (279.4 mm).
Power button — press this button to turn the scanner on or off.
Exit stopper — located on the exit tray, the exit stopper can be
positioned to accommodate the length of the documents being fed
through the scanner.
Exit tray — collects the documents after scanning. The scanned
documents will be deposited face-down in the exit tray.
Power indicator
Stop/Start
Transport
cover
Auto/Manual
Feed selector
ADF door
release
ADF door
Document guide
Separation roller Feeder tray
Feeder tray
extension
Power
button
Exit tray
Exit stopper
To Next Page
Loading...
