A-61660 July 2013 6-9
Cleaning the flatbed
(3210 Scanner)
1. Raise the feeder tray until the tray clicks into place.
2. Open the document cover.
3. Clean the surface of the flatbed glass with a Staticide wipe. If
required, clean the surface of the flatbed sheet.
4. Use the blower accessory to blow off any dirt that may have
accumulated in the area of the document cover detector.
5. Gently close the flatbed cover and lower the feeder tray.
Document cover
Feeder tray
Document cover
detector
Flatbed glass
To Next Page
Loading...
