6-8 A-61660 July 2013
Cleaning the starting, skew and ending sensors
1. Pull the exit door release lever to open the exit door.
2. Blow off any dirt from the surface of the starting sensor, right and left
skew sensors and ending sensor.
3. Blow off any dirt from the reflector sheets for the starting sensor,
skew sensor (left), skew sensor (right) and the ending sensor.
4. Gently close the exit door.
Ending sensor
Skew sensor
Starting sensor
Skew sensor
Reflector sheet for
skew sensor (left)
Reflector sheet for
starting sensor
Reflector sheet
for skew sensor
(right)
Ending sensor
To Next Page
Loading...
