Kodak Truper 3210 - Scanning with the Flatbed (3210 Scanner)

3-10 A-61660 July 2013
Scanning with the
flatbed (3210
Scanner)
You can use the flatbed on the 3210 Scanner to scan a single sheet,
exception documents or documents that you do not want to take apart
before scanning (e.g., books, magazines).
NOTE: Do not place floppy disks or any items containing magnetic
media on the flatbed.
1. Raise the feeder tray up until the tray clicks into place.
2. Open the document cover.
3. Select Flatbed Mode in the scanning application.
4. Place the document face down in the upper left corner of the flatbed
glass.
5. Place the shorter edge of the document along the left edge of the
flatbed glass. Match the shorter edge with the standard mark.
6. Place the longer edge of the document along the top edge of the
flatbed glass. Match the longer edge with the standard mark.
NOTE: If the document is not properly aligned, the document will
not scan correctly.
7. Gently close the document cover.
NOTES:
• When scanning thick documents such as a bound book, only the
areas that are touching the flatbed glass will be scanned.
• Do not open or press down on the document cover during the
scanning process.
• When using the flatbed for a series of documents, keep the feeder
tray raised. You only need to raise and lower the document cover
when you scan each document.
Feeder tray
Document cover
Standard mark