1-4 A-61660 July 2013
Front view — Kodak Trūper 3210 Scanner
Exit tray — collects the documents after scanning. The scanned
documents will be deposited face-down in the exit tray.
Transport cover — provides access to internal components.
Auto/Manual feed selector — set this selector to AUTO if you are
feeding a stack of documents. If you are feeding documents one at a
time, set the selector to MANUAL.
ADF door release — push this button to open the ADF door.
ADF door — provides access to the internal components of the
scanner.
Separation roller — allows the paper feed roller to feed a single
document into the scanner.
Document guides — slide the document guides in or out to
accommodate the size of the documents you are scanning.
Feeder tray — holds documents in place for automatic or manual
scanning. The documents should be placed face-up to ensure they are
scanned in the correct order.
Feeder tray extension — pull this extension out to accommodate
document sizes longer than 11 inches (279.4 mm).
Back stopper — prevents documents from falling off of the exit tray if
you lift the flatbed cover after the documents have exited from the
scanner.
Exit stopper — located on the exit tray, the exit stopper can be folded
down or positioned to accommodate the length of the documents being
fed through the scanner (not shown in this illustration).
Power indicator
Stop/Start
Power switch
Transport cover
Exit stopper
Back stopper
Feeder tray extension
Feeder tray
Document
guide
ADF door
ADF door
release
Auto/Manual
feed select
Exit tray
Separation roller
Flatbed
To Next Page
Loading...
