3-2 A-61660 July 2013
Determining your feeding
mode
The scanner has an Auto/Manual feed selector switch. This switch must
be placed in the correct position depending on your scanning needs.
You can scan in Auto mode or Manual mode.
Auto mode — use Auto mode when you are scanning a batch of
documents. The feed selector switch must be in the Up position. Use
Auto to lower the feeder tray between each batch and restart scanning
immediately. To feed documents in Auto mode:
1. Set the feed selector switch to Auto. The feeder will adjust
automatically to the automatic feed position.
2. Verify that the document guides are adjusted to fit the size of the
documents you are scanning (slightly wider than the size of the
documents in the batch).
3. On the PC, click the Start/Batch button in the scanning application.
Place your documents into the feeder tray. The feeder tray will rise
and automatically feed the batch of documents in the feeder tray.
Manual mode — use Manual mode when you want to feed one
document at a time or thicker documents. The feed selector switch
must be in the Down position. Manual mode is not recommended for
multiple or batch feeding.
1. Set the feed selector switch to Manual. The feeder will adjust
automatically to the manual feed position.
2. Verify that the document guides are adjusted to fit the size of the
documents you are scanning (slightly wider than the size of the
document you are scanning).
3. Insert one document into the feeder tray with the top side facing up.
To Next Page
Loading...
