A-61660 July 2013 4-9
Manual Feed mode — select one of the following options for your
scanning needs.
• Off — if you select this option, you will need to load the documents in
the scanner and click Start Batch (or a button with similar name) in
the scanning application to start scanning.
•On — select On when manually feeding documents. This should be
selected when feeding mixed document types that are difficult to
separate and may cause multifeeds. In this mode, the ADF is raised
and the feeder rollers are not engaged until the document’s leading
edge approaches the feeder roller.
• Start Button — if selected, the scanner will not start feeding until the
Stop/Start button is pressed.
• Automatic — this is the standard mode of operation. In Automatic
mode, the “out of paper” indication is displayed immediately after a
batch has been scanned. This is the default.
• Timeout — allows you to set the amount of time the scanner will wait
after the last document enters the transport before the transport
timeout action is taken. You can specify a time delay setting from 1 to
300 seconds.
NOTE: The Timeout option is active in all Manual Feed Mode options
except for Off.
• Unlimited — this is unlimited timeout. It is only available in the Start
Button and Automatic modes.
• Detect Control Sheet — if this option is checked, the scanner will
detect when a control sheet is placed in a batch and change the
scanner's settings (i.e., color mode) accordingly.
• Skip Control Sheet — if this option is checked, the scanner will not
generate an image of the scanned control sheet.
To Next Page
Loading...
