B-2 A-61660 July 2013
3. Connect the imprinter cable to the connector on the scanner.
NOTE: Before you insert the connector, be sure to match the rib on
the imprinter cable connector with the slot on the scanner
connector.
4. Insert the upper pins on the imprinter unit into the guides located on
the bracket. Match the channels in the pins with the guides.
5. Insert the lower pins into the guides located on the bracket. Match
the channels in the pins with the guides. Gently insert the pins until
they are locked in place by the springs.
6. Gently close the imprinter door.
To Next Page
Loading...
