C-2 A-61660 July 2013
5. Insert the DIMM module into the module connector on the interface
board at an angle.
6. Push the module in until it clicks into place and the white tabs on the
module connector close around the DIMM module.
7. Be sure the indent on the DIMM module is to the left side when you
insert the DIMM module. If the indent is not in this position, the
DIMM module will not be inserted properly.
NOTE: If you need to remove the DIMM module, pull the white tabs
at both sides of the module connector to release the DIMM
module, then carefully pull it out.
8. Slide the interface board back into the unit by guiding the board into
place along the rails located inside the scanner.
9. Push the board in firmly until it locks into place.
10.Confirm that the interface board is fully inserted and firmly locked in
place, then secure the interface board with the two retaining screws.
To Next Page
Loading...
