English
27
Insert paper into the paper support
1 Reach your hand to the back of the unit, just above the Rear cover
(Duplex Unit), and lift up the center of the Paper Support.
2 Tilt the Paper Support forward, then tilt it backward so that the
Paper Support is fixed in the right position.
3 Pinch the Paper Support Bar at the rectangular cutout on the right
of the Paper Support, and rotate it upward.
1
2
3
4 Slide the paper guide to left.
5 Fan the plain paper to be printed and then tap the paper sheets so
the ends are the same.
6 Insert the paper into the paper support. You can load up to 100
plain paper sheets (20 lb. or 75 g/m
2
). Slide the paper guide firmly
against the edge of the paper.
1
2
7 Paper Detection screen will be displayed in the Menu display.
Press
to change the settings, or press to use the
current settings.
»»
Refer to “Paper Detection” on page 49 .
Paper Detection
Press to use
current settings.
Paper Size Letter
Paper Type Plain
Change
8 If is selected, press to select Paper Size and
Paper Type, then follow the on-screen instructions to configure.
Cancel Select
Paper Detection
Letter Plain
Letter Glossy
4x6 in. Glossy
other
Note(s)❏
• By selecting [other], Paper Size and Paper Type can be
configured separately.
»»
Refer to “Print settings” on page 29 .
9 Open the paper exit tray and exit tray extender.
1
2
Pull out the Paper Exit tray all the way
before opening the Exit tray extender.
Continued on next page.
To Next Page
Loading...
