Kodak Verite 65 Plus - Order Supplies; Software Update; Login Password

English
56
•
Google Cloud Print™
You can set the Google Cloud Print™ settings.
• Registration and connection status of Google Cloud Print™ will
be shown. More information can be found under “Google Cloud
Print™”.
»»
Refer to “Google Cloud Print™” on page 50 for more information.
• The printer name and its information are displayed when you are
using Google Cloud Print™.
Action
You can set the following for the Google Cloud Print™ setting.
After you select the Action, click on [Accept].
Select Action Action
Register to Google Cloud
Print
Register to Google Cloud Print™
Disable Cloud Print Disable Google Cloud Print™
Suspend Cloud Print Suspend Google Cloud Print™
Enable Cloud Print Enable Google Cloud Print™
Resume Cloud Print Resume Google Cloud Print™
Unregister from Google Unregister from the Google Cloud Print™
Register Cancel Cancel the Google Cloud Print™
registration
Set XMPP Ping Interval Set the interval time to communicate
with the Google Cloud Print™ service.
*Usually, set the XMPP ping interval to 5 minutes (default).
To change this setting, select [Set XMPP Ping Interval] in [Select
Action] and choose the communication interval from 1 minute to 10
minutes.
Note(s)❏
• When you select [Register to Google Cloud Print], then ensure
plain Letter or A4-size paper is loaded.
Order Supplies
If you would like to purchase consumable material, visit the following
website at www.kodakverite.com
Software Update
• If the Software Update for this unit is available, the Update
button is displayed. Press it and start to update the Software.
• When the Software is the latest version, the Update button is not
displayed.
Login Password
• Once you have logged in to the Web interface with “admin”, it is
recommended that you change the Password.
Note(s)❏
• Record the Password in case you forget it.
• If you have forgotten the Password, you can perform [Restore
Factory Default] to reset all settings, including the Password, to
their factory default. After resetting the unit, you can login with
the default Password “admin”.
• Passwords may only contain alphanumeric characters, and are
from 1 to 32 characters in length.
• default Password “admin” provides you with full access to all
setup functions, but can allow access by an unauthorized third
party. It is recommended that you change the Password.