English
43
Settings
You can setup the unit as you like depending on your needs.
Maintenance
You can perform maintenance operations for the ink cartridge.
•
Clean Printhead
1
From the Control panel, navigate to
[Home > Setup > Maintenance], then press
.
2 Press to select [Clean
Printhead], then press
.
3 Load plain Letter or A4 -size paper.
Maintenance
Clean Printhead
Cartridge Setup
Back Select
4 Press to start cleaning the printhead.
Clean Printhead
Please insert
Letter or A4 paper
and press
.
Cancel Start
5 A page prints, forcing ink through the ink
cartridge nozzles to clean them.
6 Print the document again to verify that the
print quality has improved.
Clean Printhead
Cleaning...
•
Cartridge Setup
Print the alignment pattern for alignment
adjustment. By reading the pattern with the
scanner, the printer alignment is optimized
and the print quality will be better.
1 From the Control panel, navigate to
[Home > Setup > Maintenance], then press
.
2 Press to select [Cartridge
Setup], then press
.
Maintenance
Clean Printhead
Cartridge Setup
Back Select
3 [Cartridge Setup] screen will be displayed
on the Menu display. Make sure plain Letter
or A4 -size paper is loaded in the paper
support, then press
.
Cartridge Setup
Step 1 of 5 :
For best results,
please proceed with
cartridges setup.
Cancel Next
4 The unit will start printing the alignment
pattern.
• The
(Power) LED will light up then
blink rapidly. LED lighting pattern is
“Blinking 5”.
»»
Refer to “Meaning of LED behavior and lights”
on page 9.
Cartridge Setup
Step 2 of 5 :
Test Print
5 Open the scanner lid on the unit. Load the
front side of the alignment pattern result
facedown at the placement corner of the
scanner glass (see below), then press
to start the alignment adjustment
after closing the scanner lid.
Cartridge Setup
Step 3 of 5 :
Place test print on
the lower right corner
of scanner. Press
.
Back Scan
6 The unit will start scanning the alignment
pattern to set an appropriate alignment on
this unit.
Cartridge Setup
Step 4 of 5 :
Test Scan
7 When alignment is completed, [Alignment
successful.] message will be displayed on
the Menu display, then press
.
Cartridge Setup
Step 5 of 5 :
Alignment successful.
Press
.
Continued on next page.
To Next Page
Loading...
