Koden CVS-841 - Image Direction; Image Partition; Image Swap; Scale

Chapter 6 CVS-841/851
Using the menu
6.6.9 Scale
Sets up the position of the depth scale on the screen. The choices are; a single scale display shown at
the right hand side of a single or dual screen or; dual scale displays shown in the left hand side of
each screen.
Selections: OFF, Single, All
Initial setting: Single
6.6.10 Scale position
Sets up the horizontal position of the depth scale on the screen, right hand side or the center.
Selections: Side, Center
Initial setting: Side
6.6.11 Scale value
Selects the size of the depth scale value.
Selection: Large, Small
Initial setting: Small
6.6.12 Time Mark
Selects the time marker on or off or time unit (every 10 seconds, 1 minute).
Selections: OFF, 10 sec, 1 min
Initial setting: 10 sec
6.6.13 Image direction
Selects the direction of image movement.
Selections: , ,
Initial setting:
6.6.14 Image partition
Selects the image split way, either in a vertical split or a horizontal split..
Selections: Vertical, Horizontal
Initial setting: (Vertical)
CAUTION: This function is not available when the image is split to 3 sections.
6.6.15 Image swap
This function allows swapping of the dual image display left side right, or up side down.
Selections: A|B, B|A
Initial setting: A|B
6-12 0093132682-05