Kohler CV11-16 - Page 10

1.8
Section 1
Safety and General Information
Balance Shaft
End Play ...................................................................................................... 0.0575/0.3625 mm (0.0027/0.0137 in.)
Running Clearance ...................................................................................... 0.0250/0.1520 mm (0.0009/0.0059 in.)
Bore I.D.
New....................................................................................................... 20.000/20.025 mm (0.7874/0.7884 in.)
Max. Wear Limit .................................................................................... 20.038 mm (0.7889 in.)
Balance Shaft Bearing Surface O.D.
New....................................................................................................... 19.962/19.975 mm (0.7859/0.7864 in.)
Max. Wear Limit .................................................................................... 19.959 mm (0.7858 in.)
Camshaft
End Play (free)............................................................................................. 0.088/0.393 mm (0.003/0.015 in.)
End Play (with shims) .................................................................................. 0.076/0.127 mm (0.003/0.005 in.)
Running Clearance ...................................................................................... 0.025/0.105 mm (0.0010/0.0041 in.)
Bore I.D.
New....................................................................................................... 20.000/20.025 mm (0.7874/0.7884 in.)
Max. Wear Limit .................................................................................... 20.038 mm (0.7889 in.)
Camshaft Bearing Surface O.D.
New...................................................................................................... 19.962/19.975 mm (0.7859/0.7864 in.)
Max. Wear Limit ................................................................................... 19.959 mm (0.7858 in.)
Carburetor
Preliminary Low Idle Fuel Needle Setting ................................................... 1 Turn
Fuel Bowl Retaining Screw Torque ............................................................. 5.1-6.2 N·m (45-55 in. lb.)
Connecting Rod
Cap Fastener Torque (torque in increments)
6 mm straight shank bolt ....................................................................... 11.3 N·m (100 in. lb.)
8 mm step-down bolt............................................................................. 14.7 N·m (130 in. lb.)
8 mm straight shank bolt ....................................................................... 22.7 N·m (200 in. lb.)
Connecting Rod-to-Crankpin Running Clearance at 21°C (70°F)
New....................................................................................................... 0.030/0.055 mm (0.0012/0.0022 in.)
Max. Wear Limit .................................................................................... 0.07 mm (0.0025 in.)
Connecting Rod-to-Crankpin Side Clearance .............................................. 0.18/0.41 mm (0.007/0.016 in.)
Connecting Rod-to-Piston Pin Running Clearance at 21°C (70°F) .............. 0.015/0.028 mm (0.0006/0.0011 in.)
Piston Pin End I.D.
New...................................................................................................... 19.015/19.023 mm (0.7486/0.7489 in.)
Max. Wear Limit ................................................................................... 19.036 mm (0.7495 in.)
Crankcase
Governor Cross Shaft Bore I.D.
New...................................................................................................... 6.025/6.050 mm (0.2372/0.2382 in.)
Max. Wear Limit ................................................................................... 6.063 mm (0.2387 in.)