Kohler CV11-16 User Manual

11.12
Section 11
Reassembly
Reassemble Cylinder Head
Refer to Figure 11-37 for cylinder head differences. Assemble the components accordingly, based on head
configuration involved.
Figure 11-37. Cylinder Head Valve Train Differences.
Round Pivot
Cylindrical Pivot
Stem Seal*
Spring Retainer*
Intake Spring
Keepers
(Retainer Kits)
Caps
Exhaust
Spring
Rotator*
Head
Bolts
Spacer
(#5 Position only)
#5
Cylinder Head
Exhaust Port
Exhaust Valve
Intake Valve
Push Rods
Head Gasket
Hydraulic Lifters
Adjusting
Nut
Pivot Stud
Set Screw
Adjustable Valve Lash
Non-Adjustable Valve Lash
Rocker
Arm
Bridge Screw
Rocker Shaft
Rocker Bridge
Rocker Bridge
3. Install the exhaust valve stem seal (if used),
exhaust valve, spring retainer*, exhaust valve
spring, and valve spring cap. Compress the valve
spring using a valve spring compressor and install
the keepers. See following NOTE regarding
exhaust valve rotator use.
NOTE: Exhaust valve rotators are no longer used. Do
not attempt to install rotators if a new head is
being installed, or head did not use one
originally.
*Not used on some models.
1. Rocker Bridge Heads Only–Install the rocker
bridge to the cylinder head. See Figure 11-38.
Make sure the small (counterbored) hole is
towards the exhaust port side of the cylinder
head. Secure the rocker bridge with the two M6
hex. cap screws. Torque screws to 11.3 N·m
(100 in. lb.).
2. Install the intake valve stem seal*, intake valve,
spring retainer*, intake valve spring, and valve
spring cap. Compress the valve spring using a
valve spring compressor and install the keepers.
See Figure 11-39.
*Not used on some models.

Kohler CV11-16 Specifications

General

Brand	Kohler
Model	CV11-16
Category	Engine
Language	English