S700 Safety Guide | 2 English
2.2.3 Prohibited Use
Other use than that described in chapter “Use as directed” is not intended and can lead to per-
sonnel injuries and equipment damage.
The use of the servo amplifier in the following environments is prohibited:
potentially explosive areas,
environments with corrosive and/or electrically conductive acids, alkaline solutions, oils,
vapors, dusts,
directly on non-grounded supply networks or on asymmetrically grounded supplies with a
voltage >240V,
ships or offshore applications.
Commissioning the servo amplifier is prohibited if the machine in which it was installed,
does not meet the requirements of the EC Machinery Directive,
does not comply with the EMC Directive or with the Low Voltage Directive,
does not comply with any national directives.
The control of holding brakes by the S700 alone may not be used in applications, where func-
tional safety is to be ensured with the brake.
2.2.4 Warning notes placed on the product
S701...712 S724 S748/772
Residual Voltage.
Wait 5 minutes
after removing power.
Residual Voltage.
Wait 8 minutes
after removing power.
Residual Voltage.
Wait 10 minutes
after removing power.
If these signs are damaged, they must be replaced immediately.
46 Kollmorgen | wiki-kollmorgen.eu | February 2017
To Next Page
Loading...
