24. SERVICE PROCEDURE
24.8 EVERY 2000 HOURS SERVICE
Maintenance for every 100,250,500 and 1000 hours should be
Prepare the following.
Container to catch drained oil: Min. 11 ! capacity
Refill capacity: 11 d (2.7 US gal, 2.4 UK gal)
Handle
i
l
l
1.
2.
3.
Set the UP mark at the top, with the UP mark and plug @
perpendicular to the ground surface.
Set a container under plug @ to catch the oil.
Remove plugs @ and @ with the handle and drain the oil.
carried out at the same time.
24.8.1 CHANGE OIL IN FINAL DRIVE CASE
AWARNING
l The oil is at high temperature immediately after the machine
has been operated. Wait for the oil to cool down before
carrying out maintenance.
l If there is still pressure remaining inside the case, the oil or
plug may fly out.
Loosen the plug slowly to release the pressure.
AE098710
REMARK
Check the O-rings in the plugs for damage. If necessary, replace
with new ones.
4. Screw in plug @.
5. Add engine oil through the hole of plug 0.
For details of the oil to use, see “20. USE OF FUEL, COOLANT
AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”.
6. When the oil overflows from the hole of plug 0, install plug 0.
Tightening
torque of plugs @ and
0: 70 + 10 Nm (7 f 1 kgm, 50
+. 7 Ibft)
3-65
To Next Page