Konica Minolta 9825 - Group Dial

56
Konica Fax 9825 User’s Manual
Dialing Methods
Group Dial
Group Dial
Group dialing transmits a document from memory to several locations without
scanning the document for each location. There are two methods of initiating
a group dial operation. You may program a group into the phonebook. If a
group has been programmed then use the following steps to send to the group.
For more information on setting up a group see the "
Setting up a Group
"
section on page 95.
1
Load the documents face down in the document feeder.
2
If desired, select any special features for the operation.
3
Enter the desired group number using Speed Dial, Phonebook Dial, or
One-Touch Dial.
4
To begin dialing, press
Start
.
The alternate group dial method is called Ad Hoc Broadcast Send. This
method allows you to enter the phone numbers “on the fly” without entering
them into the phonebook first.
➙
To send an Ad Hoc group broadcast:
1
Load the documents face down in the document feeder.
2
If desired, select any special features for the operation.
3
Enter the first telephone number using one of the dialing methods.
If one-touch is used to dial the first number, you must disable automatic
start by pressing
Enter
within 3 seconds or by selecting the Cancel Auto
Start feature. See the "Pauses and other Dial Options" section on page 57.
4
Press
Enter
.
5
Enter the next telephone number using one of the dialing methods.
6
Press
Enter
.
7
Perform steps 5 and 6 to enter each additional telephone number.
8
When all numbers have been entered, press
Start
.