1
1Getting Started
Operatin
Notices
Your machine and supplies have been designed and tested to meet strict safety
requirements. These include safety agency examination and approval, and compliance
to established environmental standards. Please read the following instructions and refer
to them as needed to ensure the continued safe operation of your machine.
Follow all warnings and instructions marked on, or supplied with, the product.
Unplug this machine from the wall outlet before cleaning. Always use materials
specifically designated for this machine. Use of other materials may result in poor
performance and could create a hazardous situation.
Do not use this machine near water, wet locations, or outdoors.
Do not place this machine on an unstable cart, stand, or table. The machine may fall,
causing personal injury or serious damage to the machine.
This machine is equipped with a 3-wire, grounding type plug (that is, a plug having a
third grounding pin). This plug will only fit into a grounding type power outlet. This is a
safety feature. To avoid the risk of electric shock, contact your electrician to replace the
receptacle if you are unable to insert the plug into the outlet. Never use a ground
adapter plug to connect the machine to a power source receptacle that lacks a ground
connection terminal.
This machine should be operated from the type of power source indicated on the
marking label. If you are not sure of the type of power available, consult your local power
company.
Do not allow anything to rest on the power cord. Do not locate the machine where
persons will step on the cord.
Use of an extension cord with this machine is not recommend or authorized. Users
should check building codes and insurance requirements if an extension cord is to be
used. Ensure that the total of the ampere ratings does not exceed the extension cord
ampere rating. Make sure that the total of all products plugged into the wall outlet does
not exceed the outlet rating.
Slots and openings in the cabinet and in the back and bottom of the machine are
provided for ventilation. To ensure reliable operation of the machine and to protect it
from overheating, these openings must not be blocked or covered. The machine should
never be placed near or over a radiator or heat register. This machine should not be
placed in a built-in installation unless proper ventilation is provided.
Never spill liquid of any kind on the machine.
Never remove any covers or guards that require a tool for removal. There are no
operator serviceable areas within these covers.
To Next Page
