8. Utility Mode Field Service Ver. 1.0 Apr. 2007
102
bizhub 163/211/220Adjustment / Setting
8.3.2 PAPER SOURCE SETUP
A. INCH/METRIC
B. TRAY1 PAPER
(1) PAPER SIZE
(2) MEDIA TYPE
Functions • To set the paper size unit of each tray.
Use • To change the size unit of the paper to be used.
NOTE
• If it is not set appropriately, auto detection of paper size cannot be made.
• Tray 2 to 5 can be set only when the optional PF-502 is mounted.
Setting/
Procedure
• The default setting is METRIC.
<Step>
1. Select the tray.
2. Select the appropriate paper size type.
INCH “METRIC”
Functions
• To set the paper size loaded in the tray/1.
Use
Setting/
Procedure
• The default setting is AUTO.
<Step>
1. Select the type of paper.
“AUTO” SIZE INPUT POSTCARD MEMORY1 MEMORY2
• When selecting “SIZE INPUT”, enter the size with the numeric keypad.
Setting range : 140 to 432 mm (Width)
: 90 to 297 mm (Length)
• The size registered on [COUSTOME SIZE MEMORY] of [Utility] is set for [Memory1]/
[Memory 2].
NOTE
• When the type of paper is set other than “AUTO”, the paper set to the tray 1
cannot be used with Fax mode.
Functions
• To set the media type loaded in the tray/1.
Use
Setting/
Procedure
• The default setting is PLAIN.
“PLAIN” TRANSPARENCY CARD ENVELOPE
NOTE
• When the media type is set other than “PLAIN”, the paper set to the tray 1 can-
not be used with Fax mode.
To Next Page
Loading...
Need help?
General
