Konica Minolta bizhub 163 Service Manual

8. Soft Switch Set Field Service Ver. 1.0 Apr. 2007
96
FK-506
Adjustment / Setting
8.6.49 SOFT SWITCH: #49
8.6.50 SOFT SWITCH: #50
• Bit 8: Can select cancel this job and print out report or start to send in case of time when
memory full condition occurs
• Bit 7: If F-NIC was install, this bit was usable in Relay box. If Bit was set, any E-mail
address could be registered in Relay box. If Bit was reset, any E-mail address could not
be registered in Relay box.
Bit
No.
Designation Function
Initial
Setting
Bit HEX
8 Reserved Reserved 0
0
7 Reserved Reserved 0
6
Print RX mailbox report
method
0: Based on RX RESULT REPORT setting
0
1: Always printing
5
Redial method if
communication fail
0: Redial again
0
1: Based on redial time interval
4
No. of rings
0
1
3 0
2 0
1 1
No. of rings 1 2 345678
Bit 4 0
0 000000
Bit 3 0
0 001111
Bit 2 0
0 110011
Bit 1 0
1 010101
No. of rings9 10111213141516
Bit 4 11111111
Bit 3 00001111
Bit 2 00110011
Bit 1 01010101
Bit
No.
Designation Function
Initial
Setting
Bit HEX
8
Transmit or cancel after
time out in “Memory TX”
0: Cancel and print out
0
4
1: Transmission
7
It is possible to register
E-mail address in Relay
box registration
0: Disable
1
1: Enable
6 Reserved Reserved 0
5 Reserved Reserved 0
4 Reserved Reserved 0
0
3 Reserved Reserved 0
2 Reserved Reserved 0
1 Reserved Reserved 0

Konica Minolta bizhub 163 Specifications

General

Print Technology	Laser
Print Speed	16 ppm
Max Paper Size	A3
Resolution	600 x 600 dpi
Copy Speed	16 cpm
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Connectivity	USB 2.0
Paper Input Capacity	250 sheets
Paper Output Capacity	100 sheets
Memory	32 MB
Type	Monochrome
Duplex Printing	Manual
Network Connectivity	Optional
Dimensions	570 x 531 x 449 mm
Zoom Range	50% - 200%