Field Service Ver. 1.0 Jul. 2007 8. Utility Mode
225
bizhub C353/C253/C203Adjustment / Setting
8.5.8 Change Password
• When conducting user authentication (MFP only), it will be displayed only when the
authentication is complete.
• This menu is available only when box administrator authentication is established during
user authentication or account track.
8.5.9 Change E-mail Address
• When conducting user authentication (MFP only), it will be displayed only when the
authentication is complete.
• It will be displayed only when the following setting is set to “Level 2.”
[Administrator Settings] → [Security Settings] → [Administrator Security Levels]
Functions • To modify the password used for the user authentication.
Use • To modify the user authentication password currently used.
Setting/
Procedure
• Enter the user authentication password with the keys on the control panel.
Current Password : Enter the user authentication password currently used.
New Password : Enter the new user authentication password to be used.
Retype Password : Enter the new user authentication password again.
NOTE
• When [Password Rules] which can be displayed by the following setting is set
to “ON”, password using the single letter or the password same with the previ-
ous one, less than 8-digit will not be modified.
[Utility] → [Administrator Settings] → [Security Setting]
• When the following setting is set to “ON”, entering the incorrect password
three times will cause access lock. When an access lock occurred, turn the
main power switch OFF, and wait for 10 seconds or more and turn main power
switch ON again to enter the password again.
[Administrator Settings] → [Security Setting] → [Enhanced Security Mode]
Functions • To modify the e-mail address which is registered as a user.
Use • To use when modifying the e-mail address currently being used.
Setting/
Procedure
• Enter the new e-mail address using the keys on the control panel.
To Next Page
Loading...
Need help?
General
