8. Utility Mode Field Service Ver. 1.0 Jul. 2007
264
bizhub C353/C253/C203
Adjustment / Setting
8.6.5 Network Setting
A. TCP/IP Settings
(1) TCP/IP Settings
(2) IP Settings
(3) DNS Host
Functions
• To set whether to enable or disable TCP/IP settings.
Use
Setting/
Procedure
• The default setting is ON.
“ON” OFF
NOTE
• When the setting is changed, turn off the main power switch and turn it on
again more than 10 seconds after.
Functions • To set whether to enter the IP address directly or to obtain it automatically.
Use • To change the method for setting the IP address.
Setting/
Procedure
• The default setting is Auto Input.
Manual Input “Auto Input”
• When it is set to [Auto Input], select the method to obtain it automatically.
DHCP Setting : ON OFF
BOOTP Setting : ON OFF
ARP/PING Setting : ON OFF
AUTO IP Setting : ON OFF
NOTE
• [ARP/PING Setting] and [Auto IP Setting] cannot be set to “OFF” simulta-
neously.
• They will all be set to “ON” when [Manual Input] is changed to [Auto Input].
• When it is set to [Manual Input], set the IP address, subnet mask and default gate
way.
Functions • To set the DNS host name.
• To set whether or not to enable the dynamic DNS setting.
Use • To enter the DNS host name.
• To set the dynamic DNS.
Setting/
Procedure
<DNS Host Name>
1. Touch [DNS Host Name].
2. Enter the DNS host name on the screen key board, and touch [OK].
<Dynamic DNS Settings>
• The default setting is No Limit.
Enable “No Limit”