116
6.1 Maintenance and inspection items
This chapter describes the inspections and cleaning
required in order to maintain the use of this device in
an optimum condition.
Quality Tool
HINT
•••••••••••••••••••••••••••••••••••••
• "Simple Check QC for CS-7" is available for check-
ing of imaging quality. Please contact our customer
service for the detail.
• For details, contact Konica Minolta technical repre-
sentatives.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
6.1.1 Maintenance schedule
The maintenance and inspection items that the user
should perform are as follows.
Maintenance task
Maintenance
interval
Checking and cleaning the surface of the
DR Detector
Weekly
Checking for external damage to the DR
Detector
Weekly
Cleaning the spring connectors of the
wired cable and AeroDR Battery Char-
ger2
Weekly
Cleaning the wired connection connec-
tors of the DR Detector and AeroDR UF
Cable
Weekly
Cleaning the AeroDR Battery Charger
and AeroDR Battery Charger2
Weekly
Full charge of the DR Detector Monthly
Calibration
Every year or
when a message
is displayed
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• To ensure optimum use of this device, be sure to
perform periodic maintenance.
• The above task intervals are estimates and vary
according to usage.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
• Perform calibration when a message that prompts
for calibration of the image processing controller is
displayed.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
Reference
•••••••••••••••••••••••••••••••••••••
• For the calibration, refer to the "Operation Manual"
or the "User Tool Operation Manual" of the image
processing controller.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
6.1.2 Cleaning
The cleaning methods of the respective devices are as
follows.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• Be careful not to apply any cleaning chemical or
liquid onto the spring connectors, the wired con-
nection connectors, and the LEDs.
•
Do not clean with sharp or hard metal objects. If you
cannot remove stains, contact Konica Minolta techni
-
cal representatives.
• Wear and deformation of the protective cover will
occur with the DR Detector due to the way it is
handled. The protective cover can be replaced for
a fee when the damage becomes extensive, so
contact Konica Minolta technical representatives.
•••••••••••••••••••••••••••••••••••••••••••••••••••••