Konica Minolta SKR 3000 - Position to Affix DR Detector Identification Label and Aerodr Grip; Sheet; Position to Affix DR Detector Identification Label; Aerodr Grip Sheet

87
Chapter 3
3.6 Position to a󰀩x DR Detector identication label and
AeroDR Grip sheet
3.6.1 Position to a󰀩x DR Detector
identication label
When using more than 1 DR Detector and affixing
identication labels (stickers) to the outside of the DR
Detectors, it is recommended to a󰀩x the labels to the
2 places ((1), (2)) shown as follows.
Position to a󰀩x DR Detector identication label
(1) (2)
(1) (2)
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• A󰀩x the labels only in the recommended places. Fail-
ure to do so may cause the labels to come o󰀨 or image
unevenness to occur.
••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
• Use of commercially available vinyl (Tepra, etc.)
labels are recommended for the identification labels
(stickers). When possible, use labels that do not easily
peel o󰀨.
• It is recommended to write the name and identication
number registered in the image processing controller
on the label.
••••••••••••••••••••••••••••••••••••••••••••••••••••
3.6.2 AeroDR Grip sheet
When using the AeroDR Grip sheet, hold the DR De-
tector as shown in the following gure.
AeroDR Grip sheet
AeroDR
Grip sheet
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• The AeroDR Grip sheet may peel off or deteriorate
depending on usage. When AeroDR Grip sheet peel
o󰀨 or deteriorate, replace them.
• For replacement AeroDR Grip sheet, contact Konica
Minolta technical representatives.
• For how to a󰀩x the AeroDR Grip sheet, refer to "6.1.5
AeroDR Grip sheet a󰀩xing and replacement".
• The AeroDR 1012HQ, AeroDR 3 1417HD, AeroDR 3
1717HD and AeroDR 3 1012HQ do not use the Aero-
DR Grip sheet.
••••••••••••••••••••••••••••••••••••••••••••••••••••