23
Chapter 1
1.3 Safety precautions
Table 1 (support for IEC 60601-1-2:2007 and IEC 60601-1-2:2014)
Guidelines and manufacture's declaration - electromagnetic emissions
This device is intended for use in the electromagnetic environment specied below.
The customer or the user of this device should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic environment - guidelines
RF emissions
CISPR 11
Group 1
The device uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class B
This device is suitable for use in all establishments including the following:
Domestic establishments and those directly connected to the public low-
voltage power supply network that supplies buildings for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage uctuations/
icker emissions
IEC 61000-3-3
Complies
IMPORTANT
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
• If I/F Cable4 8mD and/or I/F Cable4 8mU is used, the emissions characteristics of this device is CISPR 11 class A
that is suitable for the industrial areas and the hospitals. If it is used in a residential environment, for which CISPR
11 class B is normally required, this equipment might not oer adequate protection to radio-frequency communica-
tion services, and it may be necessary to take a mitigation measures, for example, by relocating or re-orientating the
device.
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
To Next Page
Loading...
Need help?
General
