Korg MONOLOGUE - Page 18

18
MIXER
ThemixerisusedtosettherelativelevelsofOscillators1and2.
VCO 1 knob [0...1023]
VCO 2 knob [0...1023]
TheseknobscontroltheoutputlevelsofOscillators1and2.
FILTER
VCF:VoltageControlledFilter
Thelow-passltershapesthetonebyselectivelylteringcertainparts
oftheharmonicspectrumofthesoundgeneratedbytheOscillators
andtheNoisegenerator.
CUTOFF knob [0...1023]
Thisknobisusedtosetthecutofrequency.Harmoniccontentabove
thecutofrequencywillbelteredout.
Turningtheknobtothelewilllowerthecutofrequency,andturningthe
knobtotherightwillraisethecutofrequency.
 IftheCUTOFFvalueissettoolow,thevolumemaybeextremely
low.
RESONANCE knob [0...1023]
AlsoknownasPeakorQ,theRESONANCEcontroladdsadditionalemphasis
totheovertonesoccurringattheCUTOFFfrequency,givingadistinctivechar-
actertothesound.
Turningtheknobtotherightwillincreasetheresonanceeect.
TIP
Theovertonesthatareemphasizedwillchangedependingonthecut-
ofrequency.Forthisreason,it’sgoodtoadjusttheCUTOFFknob
whileadjustingtheRESONANCEknob.
 Whenemphasizingtheovertonesinthisway,thesoundmaydistort
dependingonthecutofrequencyortheinputaudio.
Low resonance value
High resonance value