Korg MONOLOGUE - Seq Edit Mode: BPM and Sequencer Parameters; Button 5: BPM Settings; Button 6: Sequencer Parameters

35
Button 12 (DUMP)
ThisbuoninitiatesaProgramdump.
TurnthePROGRAM/VALUEknobuntil“PressWRITE”isindicatedinthedis-
play.TheWRITEbuonwillblink.
PresstheWRITEbuontosendaSysExProgramdumpfromthemonologue’s
MIDIOUTandUSBBconnector.Thedisplaywillindicatethemessage“Pro-
gramDump”.
SEQ EDIT mode
Button 5 (BPM)
BPM [10.0...600.0]
ThisparametersetsthetempooftheSequencerinBeatsPerMinute(BPM).
Button 6 (SEQ PARAMETER)
ThisgroupprovidescontrolofvariousSequencertimingandresolutionpa-
rameterssuchasGateTime,Swing,etc.
Step Length [1...16]
StepLengthallowsyoutosetthenumberofstepsusedbytheStepSequencer.
TIP
YoucanalsosetthenumberofstepsbyturningthePROGRAM/VAL-
UEknobinsteprecording.
Step Resolution [1/16, 1/8, 1/4, 1/2, 1/1]
TheStepResolutionisusedtosetthelengthofeachStepSequencerstep.
1/16:Asinglestepwillbesettothelengthofasixteenthnote.
1/1:Asinglestepwillbesettothelengthofonemeasure.Usethiswhenyou
wanttoplaylongchords.
Swing [−75%...+75%]
TheSwingparameteradjuststheintensityoftheswing.
Default Gate Time [0–100%]
TheGateTimeisthedefaultvalueusedforeachsteprecordedusingtheStep
Sequencer.Lowervaluesaremorestaccato,highervalueshavealongergate
time.