BA 35203_04 * 3.0 * 35203_04_04_Inbetriebnahme_04.fm 4-53
Putting into operation 4
Preparing machine travel on public roads
• Remove attachments that are not authorized for travel on public
roads – see chapter 3 “Use of attachments on the machine” on
page 3-11.
• Empty the attachment completely and secure it
– see chapter 5 “Pick up the attachment” on page 5-58.
• Set the loader unit to transport position (ground clearance about
250 mm/9.84 in) – see chapter 5 “Machine travel on public roads with
a bucket” on page 5-75.
• Set the steering column to the front position – see chapter 5 “Steering
column height and angle adjustment” on page 5-1.
• Install the protection on the leading edge of the bucket.
• Fold up and secure the fork arms of the pallet forks.
• Switch off the working lights during machine travel on public roads
– see chapter 5 “Working lights” on page 5-27.
• High-speed version (30 or 40 km/h/18.64 or 24.85 mph): switch the
steering system to front axle steering
– see chapter 5 “Front axle steering” on page 5-6.
• Switch on the load stabilizer (option) – see chapter 5 “Load stabilizer
for loader unit (option)” on page 5-132.
• Secure joystick (loader unit) and the 3rd control circuit of the loader
unit
– see chapter 5 “3rd control circuit” on page 5-40.
• Check all signalling and light systems for correct function.
• Remove the protective screens for the front window and/or the main
lights (options) – see chapter 5 “Protective screens for front window
and/or main lights (option)” on page 5-129.
• Lock the cabin door and the hinged window.
• When using a trailer, ensure that the trailer is safely locked in the tow
hitch and that the loads are safely tied down on the trailer.
• Adjust the correct seat position – see “Operator seat” on page 4-8.
• Fasten the seat belt – see “Engine cover lock” on page 4-17.
• Check and if necessary adjust the rearview mirrors – see “MIrror
adjustment on the left” on page 4-5 and “Mirror adjustment on the right”
on page 4-6.
To Next Page
Loading...
