To browse the VP-440X webpages:
1. Open your Internet browser.
2. Type the IP number of the device in the Address bar of your browser. For example, the
default IP number:
The controller application page appears.
Figure 9: Embedded Webpage with Navigation List on Left
3. View the FW version and IP address.
4. Click the tabs on the left side of the screen to access the relevant webpage.
The VP-440X enables performing the following:
• Loading and Saving Configurations on page 25.
• Entering Standby Mode on page 26.
• Configuring Video Input Settings on page 26.
• Switching an Input to the Outputs on page 27.
• Freezing / Blanking Video Outputs on page 28.
• Adjusting Microphone and Output Volume on page 28.
• Viewing Device Settings on page 29.
To Next Page
Loading...
