Kramer VP-440X

Kramer Electronics Ltd.
VP-440X – Operating and Controlling VP-440X
11
Using the OSD Menu
VP-440X enables controlling and defining the device parameters via the OSD, using the front
panel MENU buttons.
To enter and use the OSD menu buttons:
1. Press MENU.
2. Press:
▪ ENTER to accept changes and to change the menu settings.
▪ Arrow buttons to move through the OSD menu, which is displayed on the video
output.
▪ EXIT to exit the menu.
The default OSD timeout is set to 10 seconds.
Use the OSD menu to perform the following operations:
• Adjusting Image Parameters on page 12.
• Selecting an Input Signal on page 12.
• Setting Output Parameters on page 13.
• Setting Audio Parameters on page 13.
• Setting OSD Parameters on page 15.
• Managing EDID via OSD on page 15.
• Setting HDCP on page 16.
• Setting Sleep Mode on page 16.
• Setting Switching Mode on page 17.
• Setting Ethernet Parameters on page 17.
• Locking Front Panel Buttons on page 18.
• Defining CEC on page 18.
• Viewing Device Information on page 19.
• Performing a Reset on page 19.
• Updating the Firmware on page 19.