Configuring Network Settings
VP-440X enables configuring network settings setting, including DHCP and static IP
addresses.
To configure network settings:
1. In the Navigation pane click Device Settings. The Device Settings page appears (see
Figure 14).
Figure 18: The Device Settings Page
2. Change the network settings as required and click Set changes.
–OR–
Select the DHCP On check box and click Set changes.
A message appears asking you to confirm the setting change.
3. Click OK to confirm the change.
The current webpage session is disconnected. To access the webpages, reload with the
new setting.
4. Click Soft Factory Reset to restart the unit.
IP address values and User/Password settings do not return to their factory default
parameters.
Network settings are defined.
To Next Page
Loading...
