Kramer VP-440X

Kramer Electronics Ltd.
VP-440X – Technical Specifications
48
Technical Specifications
Inputs
4 HDMI
On female HDMI connectors
1 VGA
On a 15-pin HD connector
5 Stereo Analog Unbalanced
Audio
On 3.5mm mini jacks
1 Microphone
On a 6.3mm jack
Outputs
1 HDMI
On a female HDMI connector
1 HDBaseT
On an RJ-45 connector
1 Stereo Analog Unbalanced
Audio
On a 3.5mm mini jack
Ports
1 Ethernet
On an RJ-45 female connector
1 DATA RS-232
On a 3-pin terminal block for serial link
extension
1 CTRL RS-232
On a 3-pin terminal block for device control
6 Contact Closure Switches
On a 7-pin terminal block connector
1 USB
On a female USB-A connector for firmware
upgrade
Video
Max. Resolution
4K@60Hz (4:4:4)
Max Data Rate
18Gbps (6Gbps per graphic channel)
Standards Compliance
HDCP 1.4 & 2.2. Supports HDR10
Max. Switching Time Between
Inputs
3 seconds
Video Latency
1–2 frames
Analog Audio
Maximum Line level
1.2Vrms
Maximum Mic level
20mVrms
Line Input Impedance
20kΩ
Line Output Impedance
500Ω
Frequency Response
20Hz - 20kHz @ -1dB
Audio THD + Noise:
0.01%, 20Hz - 20kHz, at unity gain
Crosstalk
-85 dB, 20Hz to 20kHz
THD + NOISE
0.03% @1kHz at nominal level
Extended Ethernet
Max Transmission Bandwidth
100Mbps
Extended RS-232
Baud Rate
300 to 115200 baud
Control RS-232
Baud Rate
115200
Extension Line
Compliance
HDBaseT 1.0
When using Kramer HDBaseT cables:
Up to 40m (130ft)
At 4K@60Hz (4:2:0)
Up to 70m (230ft)
At full HD (1080p @60Hz 24bpp)
Controls
Rear Panel
Input-select remote contact closures
Front Panel
Input-select buttons, menu buttons, reset
resolution button, panel lock button, mic
mode select switch
Power
Consumption
5V DC, 3700mA
Source
5V DC, 4A
Environmental
Conditions
Operating Temperature
0° to +40°C (32° to 104°F)
Storage Temperature
-40° to +70°C (-40° to 158°F)
Humidity
10% to 90%, RHL non-condensing
Regulatory Compliance
Safety
CE, UL, FCC
Environmental
RoHs, WEEE