Configuring Automatic Switching Settings
See Setting Switching Mode on page 17 for auto switching option details.
To configure automatic switching settings:
1. Click Advanced on the Navigation List (see Figure 25).
The Advanced page appears.
2. Open the Auto Switching drop-down box and select:
▪ Off – Disable auto switching.
▪ Scan From HDMI – Set auto-scanning and select the HDMI 1 input from which to
begin the scanning.
▪ Scan From PC – Set auto-scanning and select PC input from which to begin the
scanning.
▪ Last connected – When detecting that a source is connected to an input (which
previously had no signal), automatically switch to that input.
Automatic switching is defined.
Defining Lock Mode
Define which buttons are disabled when you click the PANEL LOCK button on the front
panel. When selecting Save modes, the front panel remains locked after power up of the
device (see Locking Front Panel Buttons on page 18).
To define the Panel Lock button:
1. Click Advanced on the Navigation List (see Figure 25).
The Advanced page appears.
2. Open the Lock Mode drop-down box and select:
▪ All
▪ Menu Only
▪ All & Save
▪ Menu Only & Save
Lock mode is defined.
To Next Page
Loading...
