Kramer VP-440X

Kramer Electronics Ltd.
VP-440X – Using Embedded Webpages
27
2. In the Video Switching area, click the edit icon on the right side of the relevant video
input.
The settings window appears for the selected input.
Figure 12: Setting Window for HDMI Inputs
Figure 13: Setting Window for the PC Input
3. If required, enter a new input name and click the save icon. The input name appears in
the webpages.
4. Click ON/OFF to enable/disable the HDCP decryption on the selected input.
If HDCP is disabled on an input, an HDCP encrypted source will not pass through
the unit.
5. Select an Audio Source (for HDMI inputs only):
▪ Analog – The analog audio input is selected.
▪ Embedded – The embedded audio in the HDMI signal is selected.
▪ Automatic (default) – The embedded audio on the HDMI input is selected for an
HDMI signal, or the analog audio input is selected if the input is not HDMI (for
example, for a DVI input signal).
6. Adjust the input volume using the slider or entering a value.
7. Upon completion, save the changes ( ) and click the exit icon ( ).
Video input settings are configured.
Switching an Input to the Outputs
To select an input to switch to the HDBT and HDMI outputs:
1. In the Navigation pane click Switching. The Switching page appears.
(Figure 11).
2. In the Video Switching area, click an input button.
The input button turns green, the corresponding input button LED on the front panel
lights.
The selected input is switched to the outputs.