▪ Check Enable to enable the command.
Figure 28: RS-232 Page – Creating a Command
6. Click Add.
Figure 29: RS-232 Page – Command Added
7. You can:
▪ Click Delete to delete the command.
▪ Click Test to test the command.
▪ Change any of the command configurations.
▪ Enable or disable the command.
Control the display via the RS-232 port.
For RS-232 control of an external device on the receiver side (for example, the display at the
HDBT receiver), set up as above, connect the CONTROL RS-232 port to the DATA RS-232
port and connect Rx and Tx on the receiver to the display.
To Next Page
Loading...
